Boekel-scientific 234100-2 UV Crosslinker AH User Manual download pdf (Page 8)

N2400340 Rev. 2 Page 8

in Energy Mode, the display shows the accumulated energy and the

calculated target time to reach that energy level.

If Time Mode is selected and the “Start/Stop” key is pressed, the

controller sounds a brief beep and the display shows the following for 1

second:

The following screen is then displayed.

TIME blinks briefly every two seconds to remind the user that they are in

Time Mode. A small UV icon appears in the upper right of the display

to show the user that the UV is energized. While in Time Mode, the

display shows the countdown time and the accumulated energy.

Pressing the “Start/Stop” key during a cycle shows the following for 1

second:

The user is returned to the main screen in paused mode where they

can adjust the target energy or time. “CYCLE PAUSED” blinks every 2

seconds to remind the user that the cycle is paused. Once the user is

finished adjusting they can press the “Start/Stop” key to continue the

cycle.

Pressing the “Reset” key sets the time back to the last entered setting

and the display shows the following for 1 second. Important: This also

resets the accumulated energy.

When the set time reaches zero in the Time Mode or the target energy

is reached in Energy Mode, the display shows “CYCLE COMPLETE” and

the alarm beep is energized 3 times. The user is returned to the main

screen and CYCLE COMPLETE is flashed every 3 seconds until a key is

pressed.

STARTING CYCLE

TIME MODE

TIME: 02:00 UV

ENERGY: 120000 uJ

CYCLE

PAUSED

CYCLE

RESET

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Boekel-scientific 234100-2 UV Crosslinker AH User Manual Page 8