Boekel-scientific 234100-2 UV Crosslinker AH User Manual download pdf (Page 5)

N2400340 Rev. 2 Page 5

compensate for changes in sample height. The Boekel UV Crosslinker

may be used in either Time Mode, in which the unit runs for a user-

defined amount of time, or Energy Mode, in which the unit runs until a

user-defined amount of energy has been accumulated.

This unit comes equipped and calibrated with a quantity of (5) 254 nm

Shortwave bulbs. Should the need arise for use of a different UV

wavelength, the bulbs can be swapped for bulbs of a different

wavelength and the new wavelength can be easily selected in the

Boekel UV Crosslinker Setup menu. The Boekel UV Crosslinker

automatically applies calibration settings for the new bulb wavelength,

maintaining accurate readings for sensed UV energy in both Energy

Mode and Time Mode. There is no need for the user to manually

recalibrate the unit when changing bulbs.

3.0 Assembly

Remove the packing materials carefully and retain for future shipment

or storage of the unit. Inspect for damage. Report all shipping

damage to the carrier immediately. Shipping damage is covered by

the carrier and repair/replacement for shipping damages must be

coordinated through the carrier. Complete and return the Warranty

Registration Card. Each package should contain:

 1 UV Crosslinker

 1 Power Cord

 5 each 254 nm Shortwave Bulbs

 Operating Instructions

 Warranty Card

4.0 Identification of Controls - See Figure 1 and 2 on Page 6

1. LCD Display

2. Power Key – used to toggle power to unit

3. Mode Key – used to toggle between Time mode and Energy

mode

4. Reset Key – used to reset parameters after completion of a cycle

5. Start/Stop Key – used to start and stop cycles

6. Up/Down Arrow Keys – used to increase or decrease parameters

7. AC Power Socket – connection point for power cord

8. Height Adjustment Knob – used to adjust the height of the bulbs

relative to the chamber floor

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Boekel-scientific 234100-2 UV Crosslinker AH User Manual Page 5