Boekel-scientific 234100-2 UV Crosslinker AH User Manual download pdf (Page 7)

N2400340 Rev. 2 Page 7

5.0 Installation

5.1 Place the unit on a flat and stable surface.

5.2 Fit the power line cord, supplied with the unit, into the

power socket on the rear of the unit and plug the power

cord into a properly grounded outlet.

6.0 Operation

The Boekel UV Crosslinker is equipped with a UV-protective viewing

window. This window protects users from harmful UV rays that are

generated inside of the unit. Do not operate the unit with the door

open or attempt to defeat the safeguards on the unit.

Upon Pressing the Power Key, the Startup Screen is displayed.

After the Startup Screen is displayed for 1 second, the Main Screen is

displayed. The colon for energy blinks, showing that Energy Mode is

selected. The Up and Down keys are used with a speedup algorithm

to set the desired target energy value.

If the “Mode” key is pressed, the colon for time blinks, showing that

Time Mode is selected. Pressing the “Mode” button toggles between

Energy and Time Modes. The Up and Down keys are used with a

speedup algorithm to set the desired countdown time value. The

default time setting is 2:00 minutes. The default energy setting is

120,000uJ.

If Energy Mode is selected and the “Start/Stop” Key is pressed, the

controller sounds a brief beep and the display shows the following for 1

second:

The following screen is then displayed.

ENERGY blinks briefly every two seconds to remind the user that they

are in Energy Mode. A small UV icon appears in the upper right corner

of the display to show the user that the UV bulbs are energized. While

STARTING CYCLE

ENERGY MODE

TIME: 02:00 UV

ENERGY: 120000 uJ

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Boekel-scientific 234100-2 UV Crosslinker AH User Manual Page 7